These are "point" (or span) walls based off components from [Devon Jones](https://www.thingiverse.com/devonjones), in particular the bits from his [ruined
...显示更多 walls](https://www.thingiverse.com/thing:2275577). Thanks so much Devon for providing all these bits!
I'm modeling after the [Hirst Arts Gloomhaven](http://www.hirstarts.com/gloom/gloom.html) approach. These are shorter than what Hirst is doing, more along the lines of a Wyloch/TrueTiles style of walls, but uneven.
As an aside, I'm doing a few uniform walls (like 2-a) with a consistent height, in case people prefer that sort of thing. A little more Wyloch-like than my first ones (although I still prefer the uneven ones, personally).
Unless your printer does some amazing bridging, you're going to need supports on these :).
Updates:
* 7/30/2018 - Added a 1-hex model with nothing overhanging, basically for use when you don't want to use another corner piece for aesthetic reasons.
* 7/28/2018 - Cleaned up 2-a model, had some internal structures that were leading to issues with my prints.
* 6/26/2018 - By request, a one-tile version with walls extending out both sides.
* 6/22/2018 - Rounded ends of 2-b, slightly lengthened 1-a. Only 2-a needs more work (AFAIK).
* 6/21/2018 - Rounded ends of three-tile version.
* 6/20/2018 - Rounded end of one-tile version, to better fit against corners.
* 6/20/2018 - First one-tile wall uploaded, also some blank tiles at the right spacing.
* 6/20/2018 - Second two-tile wall uploaded, first three-tile, more irregular like the flat walls.
* 6/19/2018 - Had provided wrong license temporarily.
* 6/19/2018 - For a few minutes, there was a totally broken example uploaded. Whoops.
