This simple piece avoids the connector to disconnect by vibrations or accidental pulling.
Can be printed without supports, best with nylon or ABS for
...显示更多 flexibility.
It's just clipped over the assembled male-female XT-60, thanks to the elasticity of the plastic (and the shape that allows it) and the edges at the extremities are preventing the separation in the longitudinal direction.
I provide 2 models:
- The model with plain bottom is the one I printed and that I use.
- The model with the hole in the bottom should be better (a bit tighter and lighter), to be printed next if I loose the first (but not tested).
