由PEX创建的PEX96 - Frame for FPV racing quadcopter

模型来自
loading...
模型描述
Hello folks

I was looking for a caged frame under 100mm for interior/exterior FPV and could not find one, so I designed my own.

This frame is designed for...显示更多 20x20mm FC and ESC mount and for 19/2035 propellers, this is a 96mm class frame with holes for 1103/1105 motors (Racerstar BR1103 and DYS BE1104 motors have been tested)

I build this frame around the parts I wanted so I recommend to check my part list:

- Piko BLX F3
- Cicada 4in1 10A or Multistar 4 in 1 10 A
- Eachine VTX03
- iPEX to SMA Mushroom Antenna
- 600TVL 120 Degree Camera
- FD800 Tiny Frsky 8CH PPM/SBUS Receiver
- DYS BE1104 6500kv Motors
- Lipo Tattu 450mah 75C, Tattu 650mah 75C and cheap Zop Power 500Mah 45C(I switched the plug to XT30)

You can use any 19/20 props, but I recommend the Furious FPV 2035-4 Propellers

It is compatible with the Eachine MiniCube and all 20x20 mounting FC and ESC.

You will need 14 M3 nylon spacers (20mm) + 28 M3 screws (6 to 8mm)

It should be very durable and lightweight depending on your filament type and quality. I would recommend using Nylon or Carbon fiber filament.

I will add mounts/adapters/parts soon (camera & VTX mount, landing pads...)
关于模型设计师
1 model upload
简介已审核