3D model of prima. The models were repaired and checked for printability.
That is a sweet vise which was created by HyMech -but i wanted to go more smaller and
...显示更多 down-scaled the files :)
After down-scaling the jaw depth was now just not enough in my opinion and therefore i made some modification to have 5mm jaw-depth.
As the screw itself went small too there is no more handle required (no big clamp force necessary for tiny parts).
another modification: slightly bigger slots on the sides
Clamping width approximately max.20mm
Printer:
Rapide Lite 200
Supports:
Doesn't Matter
Resolution:
0.1mm
Notes:
Infill Base&Slider: 15-20% with 2 shells with slow print speed
Infill Screw: 100% with 2 shells with slow print speed
depending on how you place the part on the bed some support is necessary
https://www.youtube.com/channel/UCkWGgSjbHl0JN86glKJZuTA
