3D model of prima. The models were repaired and checked for printability.
charger stand for AMAZFIT GTR 2 and the newly released GTR 2e smartwatch
consist of 2
...显示更多 parts screwed together with 3x countersunk screws (M3 x 6-8mm)
and the cable is hidden inside a small slot which goes down to the backside of the stand.
the charger which comes with the watch should have slightly press-fit size into the
pocket but in case it is too tight simply use a hobby knife to enlarge a little bit.
you need to thread the M3
no support required (just place the part on the bed as they show up here)
Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
10-20%
https://www.youtube.com/channel/UCkWGgSjbHl0JN86glKJZuTA
