3D model of aubenc. The models were repaired and checked for printability.
WARNING: You'll be always late if you use this to know what time is it!
So... no,
...显示更多 this don't work but it's so beautiful to see :-)
In fact, the gear assembly with a ratio 1:3600 (I'm I right? or I just talk nonsenses... everything is possible...) however the gears work perfectly.
My only contribution in "ClockGearStack4.scad" is put the gears apart so you can generate the one you need.
Print:
the pendulum set
one of each wheels
2x supports. There are 2 versions provided, use whatever the one you like or one of each to try... The "gap one" is intended to give better results with the 3mm holes, it works wonders with my cupcake but... bot#1334's hot end is a little bit special.
Careful center the build platform of the cupcake for the supports! (it may not fit if it is printed with raft enabled)
You'll need to trim the ends of the escapement...
Use some bits of filament to put all together.
