3D model of uwcharlie1983. The models were repaired and checked for printability.
This a weighted poker card capper. It is placed on your hole cards during a hand
...显示更多 to make sure they are not accidentally folded. The base is designed with the same diameter (39mm) as a standard size poker chip so this will stack perfectly on your chips when not in use.
This design is Liverpool FC's "Liverbird" logo.
--- Printing ---
1) Print two of the Liverpool_Liverbird_Negative parts. I only have a single extruder so I set the printing of these parts to pause at a height of 2.55mm for a color change.
2) Print one each of the other parts
3) I printed the holder (upside down) and base with line support material spaced at 4.5mm.
--- Assembly ---
1) The holder is designed to have 4 nickels placed inside of it as ballast prior to it being snapped into the base.
2) Put super glue in the slot in the base and on the back of the two Liverbird parts. Put the two Liverbird parts back to back and press them into the slot in the base.
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
0.1mm
Infill:
10%
Post-Printing
The fit into the base slot is tight. Depending on your printer it might be worth slightly shaving the tabs that go into the slot.
