3D model of teachingtech
The models were repaired and checked for printability.
When fitting the DD E3 mod (direct drive Ender 3) by Barasaba Innovations, I was
...显示更多 unable to refit the Hero Me fan duct and BLtouch mount. This was not the fault of either design, they are simply incompatible with each other.
This remixed base will clear the new DD E3 extruder position and retain the ability to fit all of the Hero Me options. This means either a 4010 or 5015 part cooling fan and each of the ABL mounts.
This is designed for the DD E3 modification, there is no need to use this base otherwise. If using this base, collect the accessories and other parts from the original Hero Me thing.
Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20%
Filament brand:
X3D
Filament material:
PLA
Notes:
For the base, you may wish to enable support from the platform only.
Post-Printing
Clean off support material. Use M3 screw to precut thread before assembly for the easier installation.
www.youtube.com/c/teachingtech
