由Johnnn_3d创建的Make #25 - Super Secret Cracker

模型来自
loading...
模型描述
3D model of faberdasher
The models were repaired and checked for printability.

This is our final and most exciting make. It's the season of giving, so we have...显示更多 hidden three secret gifts inside three crackers. We hope you enjoy them. Try not to peek as you print!

Seasons greetings from everyone at Faberdashery!

We've created a 'Starter Test Kit' to help tune in your machine before going for the full build. You might want to check your bed adhesion, bridging, retraction and slicing for fine features.

Print at ~0.3mm layer height, 2x shells (/perimeters) and 2-5% infill (although should be self-supporting at 0%). Each cracker requires ~34g of material (~4m of 3mm / ~12m of 1.75mm filament). Printed in gorgeous Faberdashery Robot Silver, Pearly White, Space Marine and Mercury Red.

The Crackers need to be gently eased off the build plate to save them breaking too early and spoiling the surprise. We suggest carefully removing the finished Cracker with Mole Grips (or equivalent) at the base. For the ultimate festive finish print in two colours, changing filament at 30mm and 70mm layers (Use Z-Pause if your machine supports it).

There are three different surprises in each cracker, that all print-in-place. Once you've pulled your crackers you can turn the ends around, string them together through the special holes and hang on your tree as a cracker decoration!
https://twitter.com/faberdasher
关于模型设计师
75 models uploaded
简介已审核