3D model of francfalco
The models were repaired and checked for printability.
My son is studying the Stone Age period at school and asked me if i could create an
...显示更多 axe for him. Based on an actual artefact, I modelled a simple 3 part axe.
Print parts in appropriate materials - wood effect handle. Stone head and material of colour choice for strapping. Just some glue needed to complete.
Please note: not to be used for hunting or gathering.
Enjoy!
Printer brand:
Ultimaker
Printer:
Ultimaker 2
Rafts:
No
Supports:
Yes
Resolution:
low res will suffice
Infill:
low infill
Notes:
I printed this with a 0.8 nozzle and 0.3 layer height. Its a little rough but does add to the character.rnrnSupports are only needed for the axe head.rnthe strapping will print okay without but add them if you wish.
Print parts in materials and colour appropriate.rnThe handle can either be printed complete (if your build area is large enough) or in 2 parts.rnrnGlue handle together, slide strapping over but do not glue until the head has been positioned in its handle slot. Pull strapping down the handle to achieve a nice tight axe head fit. Glue all parts.
http://twitter.com/francfalco
