3D model of ajade
The models were repaired and checked for printability.
A lever and cage, both scaled to 28mm. The cage should fit most medium creatures with a 1
...显示更多 inch base or smaller, though if they have parts that stick out beyond their base then they will probably get caught. The cage can also be used as a dice Jail, you'll want to print it at 89% scale to get it to fit snugly, though the default size would work too.
Surely no-one is stupid enough to pull a lever in the middle or a dungeon room? Is there anything good that could possibly happen? Perhaps a door will open up filled with treasure? Or perhaps a rusty old iron cage will fall from the ceiling and capture the foolish lever-puller? That's for you to decide!
The example terrain was printed on an ender 3 and painted with citadel paints. The final cage model is actually 10% bigger then the printed example as I found it a touch too small to hold 1 inch base.
http://twitter.com/Liennaslog
