3D model of deweycat
The models were repaired and checked for printability.
This is a three part print of a terrain piece for any 28mm game table, but I built it
...显示更多 for Bolt Action.
I started with the accredited file, expanded and widened it to allow a span of 5"+, but still fit my print bed (210mm).
I used cutting features on Tinkercad to try to get the ramps that go on each end to mate, but after the test print, even though they showed a gap in the program, I still had to do some surgery with a exacto blade to get them to fit. I glued the ramps to the bridge with epoxy, then filled the gap with Tamiya putty. i then primed, painted with a medium to dark grey, applied a gloss varnish, did a wash, dry brushed lighter grey and some medium brown. I used PVA glue to affix a sand / kitty litter mix on the roadway, and the flock on the side. Lastly I sprayed it with a dead flat spray varnish.
Supports:
Yes
https://www.facebook.com/deweycatproductions
